Advance Adapters 716138-1 - Manual (Page 5)

CHEVY TH350/700R AUTO TRANSMISSION TO
JEEP 4.0L, ENGINE BLOCKS NEW STYLE
ADVANCE ADAPTERS INC. P/N: 716138-1
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 5 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 02-15-08
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are
normally available at automotive dealerships
When replacing a manual transmission with a GM automatic transmission, you will need new shorter crank bolts to mount
the new flexplate to your engine. These bolts can be obtained at your Jeep dealer under Part No. J3151407. Along with
these bolts, Jeep also used a bolt ring on the flexplate to strengthen the
bolting surface. This ring is Jeep Part No. J3214094.
The installation of a kickdown cable is recommended on the T350 and
T400 transmissions, and is required on a 700R transmission install. The
problem comes into play on how to connect the kickdown cable to one
the various Jeep throttle linkages. Most installations will require some
fabrication to accomplish this. On the Jeep TJ with a 4.0L 6 cylinder,
we installed the 700R transmission and was able to use a 52" GM cable.
This cable mounted to the stock throttle linkage bracket and required
just a simple retaining bolt. The 52" cable is hard to find, so we offer
it under
P/N 716138-KD .