Advance Adapters 716129 - Manual

ADVANCE ADAPTERS INC. P/N: 716129
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-22-98
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 1 716129-BLK STEEL PLATE
2. 6 723115 SPECIAL FLAT WASHERS
3. 6 723122 5/16" FLAT WASHERS
4. 2 723718 3/8"-16 x 1" F.H.C.S.
5. 3 723721 3/8"-16 x 1" H.H.C.S.
6. 2 723723 3/8"-16 x 1-1/2" H.H.C.S.
7. 4 723732 3/8"-24 x 1" H.H.C.S.
CHEVY ENGINE ILLUSTRATED
3/8" SPECIAL FLAT WASHER - TWO (2) REQUIRED TO EQUAL
THICKNESS OF PLATE. USE BETWEEN STARTER RING AND
CONVERTER.
ALIGNMENT PINS ON BOTH SIDES MUST INDEX INTO
THE TRANSMISSION OR BELLHOUSING ADAPTER
PLATE AND ENGINE.
STEEL PLATE BOLTS TO BLOCK USING FLAT HEAD
SCREWS. THEN BELLHOUSING OR TRANSMISSION
BOLTS BACK TO STEEL PLATE.
BUICK TRANS BELLHOUSING TO
CHEVY ENGINE BLOCK
BOLT FLEX PLATE TO CRANK USING
ORIGINAL BOLTS
INSTALLATION INSTRUCTIONS:
Stock converter will need to be spaced back from flexplate using (2) 3/8" flat washers on each bolt,
three places on flexplate using hex head cap screw 3/8"-24 x 1" with nuts and lock washers.