Advance Adapters 50-0408 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-0408
P.O. Box 247, 4320 Aerotech Center New Item: (08/97)
Paso Robles, CA 93447 PAGE 1 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 07-16-13
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that
a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
1. 1 51-8900 CASTING (with sensor drilled) (Ref: 711189)
2. 1 52-8300 SPUD SHAFT WITH 19 SPLINES (Ref: 711383)
3. 1 300619 SENSOR
4. 1 715547 TRANSFER CASE SHIFTER BRKT.
5. 3 715548 TRANSFER CASE BRKT. SPACERS
6. 1 716142 BUSHING/GEAR LOCATER
7. 1 716310 SEALED BEARING
8. 1 716321 SPECIAL SNAP RING FOR 716310 BEARING
9. 1 716511 "O"-RING
10. 1 716571 GASKET
11. 1 716758 TRANSFER CASE FRONT INPUT SEAL
12. 3 720062 12mm-1.25 x 90mm LONG H.H.C.S. (transfer case to adapter housing bolts)
13. 4 720063 12mm-1.25 x 40mm LONG H.H.C.S. (transfer case to adapter housing bolts)
14. 1 *720090 12mm-1.25 SET SCREW (INSTALLED BY AA)
15. 3 723734 3/8"-16 x 2-1/2" S.H.C.S.
16. 7 724302 FLAT WASHER
17. 1 728703 26mm - 1.5 SHAFT NUT
18. 1 TLC001 LAND CRUISER INSTRUCTION MANUAL
GM 4L60E AUTOMATIC OVERDRIVE
TO LAND CRUISERS 1980-89 FJ60 (4 SPEED)
NOTE: THIS KIT USES A 2WD 4L60E OUTPUT SHAFT (O.A.L. 18-3/16").
NOTE: This kit requires the 2WD output shaft to be shortened. If you are using this kit on a newer hex bolt
pattern 4L60E transmission, then you will be required to use our 51-0405 adapter housing. Please note that the
cut off location on the output shaft must be made after this adapter is installed on the transmission. This 51-0405
adapter make the hex pattern 4L60E transmission look just like the square bolt pattern transmission, and the cut
off location for the output shaft is shown on this instruction sheet is for the square bolt pattern transmission.
If your transfer case was coupled
to a manual transmission, Toyota
used a single lip seal in the front of
the transfer case. We recommend
changing the seal with a double
lip seal that was used on the stock
automatic applications.
Toyota # 90316-48003
SPECIAL NOTE: You may be required to change out the snap ring on the 308 bearing. The split-style
transfer case used two different diameter snap ring groves in the case. We have included both snap
rings to fit both styles of transfer cases.