Buhler 6000 HQ6095 - Manual (Page 16)

bühler
1500 Bale Carrier
14
5. Bale Pusher Operation
CAUTION
To avoid misbalanced loads the operator is only required to
push back one bale length to prepare for the next bale.
NOTE:
Lower loading arm before operating the pusher.
Depress and hold PUSHER BACK and move bales far enough to the rear to
provide room to load the next bale.
Return pusher all the way to the front by depressing and holding PUSHER FWD.
Hi speed / Low torque mode is recommended for normal use.
Low speed / High torque mode is for heavier payloads or situations where bales
are wet or resist sliding.
6. Transporting 1500 Bale Carrier
WARNING
Do not tow over 20 mph (32 km/h) when loaded. Turn on
flashing lights when transporting on public roadways. Obey local regulations regarding
road transport. Raise bale lift arm and use the safety chain when transporting. Ensure
the lift arm chain latch is used to prevent the safety chain from dislodging or loosening.
Do not transport if end bale is overhanging
beams. Beam should extend beyond last bale
for a minimum of 2’ (61 cm).
Raise lift arm prior to transport. Always
engage
lift arm safety chains when
transporting on public roadways or when not
in field. Lock chain in position with latch
provided.
Monitor the condition and position of bales
that are being transported.
Slow speed when transporting over bumps or
rough terrain.
LIFT ARM
SAFETY CHAIN
LATCH
LIFT ARM SAFETY CHAIN
ILLUSTRATION