Advance Adapters 50-8902 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-8902
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711089-16
Paso Robles, CA 93447 PAGE 1 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-02-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that
a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at
automotive dealerships and parts stores.
OPTIONAL ITEMS:
Qty Part No. Description
1. 1 51-7300 CASTING (Ref: 711173)
2. 1 51-8500 ADAPTER HOUSING (Ref: 711185)
3. 1 52-1600 SHAFT (Ref: 711316)
4. 1 52-8900 700R-4 OUTPUT SHAFT (Ref: 711389)
5. 1 Pack 714203 BOLT PACK (50-7300)
6. 1 715521-BLK T/C SHIFTER LINKAGE BRKT.
7. 1 716082 700R PLASTIC WASHER
8. 1 716301 BEARING
9. 1 716507 T/C GASKET
10. 2 716511 "O"-RING
11. 4 720015 METRIC WASHER
12. 4 720047 H.H.C.S. 10mm X 1.5 X 70mm LG.
13. 1 728701 NUT
14. 1 728702 7/8" FLAT WASHER
15. 1 TLC001 LAND CRUISER INSTRUCTION MANUAL
1 716004 CROSSMEMBER ASSY
(Includes #716003 Mount)
GM 700R-4 AUTOMATIC OVERDRIVE TO
LAND CRUISERS 1974-AUGUST 1980 (4 SPEED)
NOTE: This kit requires the 2WD output shaft
to be shortened. If you are using this kit on a
newer hex bolt pattern 4L60E transmission, then
you will be required to use our 51-0405 adapter
housing. Please note that the cut off location on
the output shaft must be made after this adapter
is installed on the transmission. This 51-0405
adapter make the hex pattern 4L60E transmission
look just like the square bolt pattern transmis-
sion, and the cut off location for the output shaft
is shown on this instruction sheet is for the square
bolt pattern transmission.