Advance Adapters 50-9902 - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 50-9902
P.O. Box 247, 4320 Aerotech Center Way Old Part No: 711099-B
Paso Robles, CA 93447 PAGE 1 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-03-96
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.
1. 1 51-9900 ADAPTER CASTING (Ref: 711199)
2. 1 52-9901 MAIN SHAFT (Ref: 711399-10)
3. 1 716036 SPACER
4. 1 716519 GASKET (Jeep T176)
5. 1 716568 GASKET (Dana 18/20)
6. 1 723701 3/8"-16 HEX NUTS
7. 1 723704 3/8" LOCKWASHER.
8. 6 723722 3/8"-16 x 1-1/4"
9. 1 723725 3/8"-16 x 2 H.H.C.S
10. 2 723730 3/8"-16 x 1-1/4" S.H.C.S
11. 1 JP001 JEEP INSTRUCTION MANUAL
JEEP T176 4-SPEED TRANSMISSION
TO JEEP DANA 18/20 T/C. (10-SPLINES)
NOTES:
1. Adapter plate part #711199, must be bolted to transfer case with bearing
retainer & bearing in position. Gear will need to be installed from rear
side of transfer case. On Dana 20, this will require rear driveshaft removal.
On Dana 18, simply remove inspection cover on back side of transfer case.
2. Drill your T176 transmission holes out so it lines up with jeep transfer case
hole. This will require approximately 3/16" with a rattail file. Use 3/8"-
16 x 2" H.H.C.S. with lock washer and nut for assembly.
3. These two locations are for two S.H.C.S. from transfer case side to T176
case. The transfer case may need to be ground away for head clearance.
4. Rear transfer case support must be moved forward to locate under T176
transmission. The case has 6-holes for mounting and rubber support.