Advance Adapters AF1300 User Manual

Advance adapters inc. p/n: af1300, Atlas flange yoke

Advertising
background image

ADVANCE ADAPTERS INC.

P/N: AF1300

P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447

PAGE 1 OF 1

Telephone: (800) 350-2223

Fax: (805) 238-4201

Page Rev. Date:

10-07-13

SPECIAL NOTE:

The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will

void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.

ATLAS FLANGE YOKE

1310, 1330 & 1350 C.V. and non-C.V. flange yoke. Spicer companion yoke numbers are as follows: (1310 C.V., P/N 211229x), (1310 non-C.V.,

P/N 2-2-939), (1330 C.V. - P/N 211631x), (1330 non-C.V., P/N 2-2-1369), (1350 C.V., P/N 212024x), (1350 non-C.V., P/N 3-2-1579).

Flange yoke may require the companion flange bolts to be installed through the yoke before the yoke is installed onto the transfer case.
This does depend on the series of companion yokes used. If the flange yoke is currently installed on your transfer case, you may be
required to first loosen the yoke retaining nut, pull the yoke away from the transfer case enough to install the companion flange bolts.
Once the bolts are in place a new lock nut should always be installed and torqued to 150 ft./lbs. to secure the yoke to the transfer case.

Torque specifications: 32 spline shafts 150 ft.lbs.

If any yoke nut is ever removed from the shaft for any reason, it should always be replaced with a new one. When installing a new yoke,
silicon should be used on the splines of the yoke, this is to prevent oil leakage down the shaft splines.

P/N AF1300

- 32 SPLINE 1310/1330/1350 FLANGE YOKE KIT

1.

1

300470

1350 NON CV YOKE

2.

1

300473

SEAL (NAT.472015)

3.

1

300476

NUT (JEEP # 4167924)

Male Index

Advertising