Advance Adapters 716009 - Manual

ADVANCE ADAPTERS INC. P/N: 716009
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 01-24-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 1 716406 BEARING CROSS
2. 1 716407 YOKE (transfer case)
3. 1 716408 STUB YOKE
3. 1 X11340 U-BOLT KIT
SPECIAL FRONT OUTPUT YOKE ASSEMBLY
FOR JEEPS USING AUTO TRANSMISSIONS
On most transmission swaps, we try to allow for proper front yoke clearance.
However, the early Dana 18 transfer cases can present a problem. The Dana
18 transfer front yoke protrudes out further than that of a Dana 20. Although front
yoke clearance can sometimes be a problem on the Dana 20, it is usually on the
early Dana 18 transfer cases with the large diameter yoke only that front yoke
clearance issues are found. The large diameter yokes on most 1965 and earlier
Jeeps will normally interfere with the transmission pan on most automatic
transmissions.
All Dana 18 & 20 applications will require the centerline of the drivetrain to be offset
1” to the driver’s side. In many cases, you will be limited on your driveshaft
diameter. This is a complete kit which would include a new stub yoke (weld yoke)
bearing cross and U-bolts.