Advance Adapters 715540 - Manual

ADVANCE ADAPTERS INC. P/N: 715540
P.O. Box 247, 4320 Aerotech Center Way New Item: (02/99)
Paso Robles, CA 93447 PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 01-02-03
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 1 715540-BLK BRACKET, GETRAG TO NV4500 1992-94
2. 1 715556 SHIFTER ROD, 12" UNBENT
3. 3 715650 BUSHINGS
4. 1 716140 BRAKE YOKE, 3/8" x 24"
5. 2 720005 COTTER PIN, 3/32" x 1-1/4"
6. 2 722523 FLAT WASHER, 1/4" PLT.
7. 2 723103 LOCK WASHER, 5/16" PLT.
8. 7 723122 FLAT WASHER, 5/16" PLT.
9. 2 723134 H.H.C.S. 5/16"-18 x 1-1/4"
10. 5 723704 LOCK WASHER, 3/8" PLT.
11. 1 723705 HEX NUT, 3/8"-24 PLATED
12. 5 723739 H.H.C.S. 3/8"-16 x 7/8" (GR 5)
GETRAG TO NV4500
SHIFT BRACKET 1992-94 (GATED)
INSTALLATION INSTRUCTIONS:
This transfer case linkage bracket is designed to replace a Getrag 5-speed with a NV4500. This bracket ONLY works
with 1992 to 1994 gated type shifters. This type of shifter can also be identified by a 3/4" x 3-1/2" stud coming off
the side of the bracket.
When installing this bracket, you must remove the original extension piece, P/N 5307690, before mounting the new
bracket to the transmission.
The bracket mounts to the right side of the transmission
(in the two back holes that mount the top cover on). We have found in some cases, it may be necessary to
bend the shifter rod to work with certain applications.