Advance Adapters 713008-NS - Manual

ADVANCE ADAPTERS INC. P/N: 713008-NS
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 1
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-07-12
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
ENGINE MOUNTING HARDWARE
1. 4 716656 LARGE RUBBER MOUNT
2. 1 713008-B BOLT PACK FOR 713008-NS
kit includes: 2 - 726202
4 - 726207
2 - 726208
NOTE: The early Advance Adapters frame brackets were a 3/16" material. Today we use a 1/4" material. If your brackets
are the thinner 3/16" material, you will notice the two rubber mounts will interfere with each other when installing. On these
applications you must grind 1/16" off the indexing hub of the rubber mount so they do not interfere.
THE 5/8"-18 NYLON NUT SHOULD BE
TORQUED TO 25 TO 30 FT./LBS.