Advance Adapters 713094 - Manual (Page 2)

ADVANCE ADAPTERS INC. P/N: 713094
P.O. Box 247, 4320 Aerotech Center Way New Item: (8/02)
Paso Robles, CA 93447 PAGE 2 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-27-12
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components.
We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals
are normally available at automotive dealerships and parts stores.
DODGE V8 WELD-IN MOUNTS
1997-06 JEEP TJ
New frame mounts welded into
position
Driver's side frame mounts welded
into position
Passengers side frame mounts
welded into position
Once the frame mounts are welded into position, the Dodge engine can be
reinstalled. We have provided new rubber indexing donuts for isolating the
engine vibrations from the frame and body. These rubber donuts index on the
top and bottom if the block mount. The large 5/8" bolt is then inserted from the
bottom of the frame mount up through the rubber mounts and the block mount.
The holes on the frame mount are slightly slotted to adjust the block inside the
frame rails. Once the block is in the correct location and the rubber mounts are
installed, tighten the 5/8" locknuts to 25-30 ft./lbs. to secure the engine location.
DODGE 360 INSTALLATION NOTES:
The Dodge 360 driver's side mount is narrower than that of the Dodge 318. When using this mount
on a 360, we have included four 1/4" spacers. These spacers need to be installed between the block
tabs and the block mount. We recommend using two on the front side of the mount and two on the
back side.
INSTALLATION NOTES:
The installation of the Dodge 318 fits well into the Jeep TJs. The application we converted used a stock engine-
driven fan, Chrysler P/N 52027888(1998 360 fan). We installed one of our custom radiators (P/N 716687) and used
a 6 cylinder fan shroud, Chrysler P/N5202792S (1998 4.0 TJ shroud). The wire harness off the 1999 Dodge 318
was spliced into the stock TJ wire loom. The service manual for the TJ and the Dodge V8 show the wire schematics
which made this fairly easy.
Optional items: 716687 - Brass radiator, 716691-AA - Aluminum radiator with transmission cooler, 716693-AA
Aluminum radiator, 716670 - Electric spal fan kit, 715542 - Jeep TJ transfer case shifter linkage bracket.
On 360/5.9L engine swaps we recommend using the aluminum radiators with the electric fan kits due to the higher
heat produced by the larger engine.