Advance Adapters 713107 - Manual

ADVANCE ADAPTERS INC. P/N: 713107
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-27-98
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 1 713107L DRIVER'S SIDE ENGINE MOUNT
2. 1 713107R PASSENGER SIDE ENGINE MOUNT
3. 1 714200 BOLT PACK
4. 1 GM001 GM INSTRUCTION MANUAL
INSTALLATION PROCEDURES:
These engine mounts are designed to bolt over the original S10 2.8 V6 engine rubbers. When used with the TH350
transmission or the original T4/T5 manual transmission, driveshaft modifications will not be required. The engine
mounts work best by first installing the welded mounts over the V6 rubbers. Install the special 7/16" hex head bolt
through the rubber and into the Advance Adapters support. Once the mounts are in position, the engine can then be
positioned into the chassis for final assembly.
The engine must be equipped with the Advance Adapters rear sump oil pan and the special oil pickup tube. With the
engine location, you will have the option of using the Advance Adapter "Slick Fit" headers, No. 717053, or stock
manifolds. For additional information, refer to the GM instruction manual.
CHEVY V8 ENGINE TO S10-S15
4WD VEHICLES
NOTE: You may need to grind the small metal tabs located on
both sides on your stock 2.8 liter V6 rubber mounts. This
may be required to fit the Advance Adapter engine mounts
over your stock rubber mounts.
ALSO: If you are using a late model block that utilizes an
engine block sensor, you will need to purchase a Brass Street
Elbow Dorman, Part #490-117. This will allow you to
retainer your sensor in the original location in order for the
block to operate correctly.