Advance Adapters 713126 - Manual

ADVANCE ADAPTERS INC. P/N: 713126
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 11-18-08
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
OPTIONAL ITEMS:
Qty Part No. Description
1. 2 4980 STOCK GM MOUNTS
2. 1 713125-C CROSSMEMBER EXT
3. 1 713126-L DRIVER'S SIDE ENGINE MOUNT
4. 1 713126-R PASSENGER SIDE ENGINE MOUNT
5. 4 716138-CS CROSSMEMBER SPACERS
6. 2 723701 3/8-16 NUT
7. 14 723704 3/8" LOCK WASHERS
8. 10 723720 H.H.C.S. 3/8"-16 x 3/4"
9. 4 723725 H.H.C.S. 3/8" -16 x 2"
10. 4 723735 3/8" FLAT WASHERS
11. 2 724301 7/16"-14 NYLON LOCK NUT
12. 2 724303 7/16" LOCK WASHERS
13. 2 724355 H.H.C.S. 7/16"-14 x 4-1/2" LONG (Grade 5)
14. 1 TT001 TOYOTA TRUCK INSTRUCTION MANUAL
CHEVY 4.3 V6-TOYOTA 4WD TRUCK ENGINE
MOUNTS - I.F.S. PREVIOUSLY V6 ENGINE
1 716881 RADIATOR
1 717056 HEADERS
* (Suspension lift required )
REQUIRED MODIFICATIONS
1. 2" Body lift required.
2. The small rib on the front differential must be ground if not using a suspension lift.
3. Driveline modifications are required.
4. Floor board modifications around the shifter are approximately 1-1/2" to 2".
INSTALLATION PROCEDURES:
These mounts must be used on Toyota Trucks that were originally equipped with a Toyota V6 and I.F.S. suspension. These
mounts are designed for use with the stock 5 speed, TH350, and 700R4 transmissions.
1. When using our oil pan, the front differential must be ground as shown in Photo #1
2. Install the stock GM mount to the engine.
3. Install the left & right motor mounts loosely to the frame perches as shown in Photos #2 & 3.
4. The distributor must be installed before installing the engine.
5. Install the crossmember mount with spacers. Leave loose so that the transfer case can move into the correct position once
the engine and transmission are bolted together (Photo #4).
6. Modify floor board as shown in Photo #5.