Advance Adapters 716117 - Manual

ADVANCE ADAPTERS INC. P/N: 716117
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 2
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-28-01
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will void
any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend that
you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a service
manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive dealerships
and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 2 715651 CLIPS
2. 1 716187 BRACKET
3. 1 716190 RIGHT PEDAL
4. 1 716191 LEFT PEDAL
5. 1 716192 SHAFT
6. 2 716194 3/8"-24 x 6" ALL THREAD (MODIFIED)
7. 2 716196 BUTTON
8. 2 716196-W 5/16" FLAT WASHER
9. 2 716197 SPECIAL HEX NUT
10. 2 716198 NYLINER
11. 2 716651 PEDAL PADS
12. 2 720005 COTTER PINS
13. 7 723701 3/8"-16 NUT
14. 7 723704 3/8" LOCK WASHER
15. 2 723705 3/8"-24 NUT
16. 4 723722 3/8"-16 x 1.25 H.H.C.S.
17. 3 723723 3/8"-16 x 1.5 H.H.C.S.
18. 14 723735 3/8" FLAT WASHER
INSTALLATION INSTRUCTIONS:
The dual swinging pedals have been designed for use in Jeep vehicles. They can be easily used on several other types
of conversions. The pedals have been designed so as to allow for the steering column to pass between the two pedals.
To install the pedals, you must first decide on the exact location to be used. Once the position is decided upon, you can
then mark the position for bolting. Drill your marked holes, and be sure to allow clearance holes for the master cylinder.
Bolt the master cylinder to the dual pedals with the firewall sandwiched between the two. After you've obtained the proper
adjustments, be sure to tighten the special hex nuts
(P/N 716197) up against the two buttons (P/N 716196) with the two
3/8"-24 nuts (P/N 723705) , locking the all thread rods into place. The dual pedal kit must be used with P/N 716118 dual
master cylinder. This is a Chevrolet item that has had the clutch and brake valves interchanged. You will notice that the
markings on the master cylinder will read just the opposite of their actual usage. The slave cylinder for the clutch can be
of many different styles or makes and will probably need some special type of mounting bracket made.
NOTE: This kit will not work with disc brake applications.
DUAL SWINGING PEDAL ASSEMBLY
USING DUAL MASTER CYLINDER
Optional Items:
P/N 716118 - Dual Master Cylinder
P/N 716116 - Slave Cylinder Kit
P/N 716287 - Slave Cylinder Bracket
(GM block only)