Advance Adapters 716138-M - Manual

KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 716138-M
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447
PAGE 1 OF 3
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 06-28-10
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of
the components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete
your conversion, we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly
of Advance Adapter components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams
and other related equipment. These manuals are normally available at automotive dealerships and parts stores.
1. 1 716138-M1 SENSOR FOR '91-96 4.0 BLOCK
2. 1 716138-SB SENSOR MOUNTING BLOCK
3. 1 722543 S.H.C.S. 1/4-20 X 1-1/2
4. 1 722544 F.H.C.S. 1/4-20 X 3/4
INSTALLATION INSTRUCTIONS:
The Crank Position Sensor Bracket retains the sensor in the stock Jeep location. This allows for the proper signal
for the 4.0L ignition timing. The stock GM automatic bellhousing must be modified prior to installation. This
is required for clearance of the sensor and bracket.
Installation:
1. This kit works with our adapter kit 716138 and 716138-1manufactured after June 1st 2010.
2. Mount the aluminum block to the adapter plate, test fit the GM transmission to the adapter plate and mark
the boundaries of the sensor block to the GM bellhousing. Measure and mark the distance that the sensor
block protrudes from the adapter plateand remove the square marked area for clearance of the aluminum
sensor block.
JEEP 4.0L AUTOMATIC ADAPTER FLEX PLATE
SENSOR KIT 1991-96