Eppendorf G0.5 µPlate - Manual (Page 22)

Operation
Eppendorf
® μPlate G0.5
English (EN)
22
5.4.2 Ending the blanking
There are two ways to end the blanking:
1. Repeat the blanking using the same plate but with white wells only (e.g., D1 – E2, as
shown in the figure above). Drag a frame around these wells.
Abb. 5-13:Purple color code
Fig. 5-13: Purple color code
The newly selected wells appear white; the deviating wells switch from pink to violet.
All other wells remain blue, which indicates that they are not being used.
2. Move the plate out, repeat the cleaning procedure, load the plate with fresh blanking
solution and start the blanking over again.