Eppendorf FemtoJet 4x v.2 - Manual (Page 35)

Operation
FemtoJet ® 4x
English (EN)
35
6.13.2 Changing the saved injection parameters
1. Change the injection parameters.
2. Keep the prog 1 or prog 2 key pressed for two seconds.
An acoustic signal will sound.
The LED above the program key is illuminated.
The new value is saved.
6.14 Adjusting the device settings
6.14.1 Change capillary function – Changing the capillary
1. Press the menu enter key.
2. Select the Change capillary menu.
3. Confirm with the menu enter key.
You can change the capillary.
4. Quit the menu with the menu enter key.
6.14.2 Pressure unit function – Selecting the pressure unit
1. Press the menu enter key.
2. Select the Pressure unit menu.
3. Confirm with the menu enter key.
4. Select the pressure unit.
5. Confirm with the menu enter key.
6.14.3 Beeper function – Switching on/off the signal tone
1. Press the menu enter key.
2. Select the Beeper menu.
3. Confirm with the menu enter key.
4. Select the mode.
5. Confirm with the menu enter key.
6.14.4 Contrast function – Setting the display contrast
1. Press the menu enter key.
2. Select the Contrast menu.
3. Confirm with the menu enter key.
4. Set the parameter value with a rotary knob.
5. Confirm with the menu enter key.
The current parameter set is overwritten. For the ex factory parameter sets, refer
to chapter “Calling up saved injection parameters” on page
34.