Eppendorf Multipette Xstream - Manual (Page 31)

31
Operation
Multipette ® /Repeater ® (X)stream
English (EN)
2. Press the actuate key.
The display shows:
3. Hold the Multipette stream/Repeater stream over a waste container or the supply
vessel and press the actuate key to trigger a "special step" without aspiration of liquid.
The reverse stroke is performed. This step is not a dispensing step.
4. Immerse the Combitip into the liquid to be aspirated. Press the actuate key to aspirate
the liquid. Repeat the process for every additional well.
The display shows the aspiration volume and the number of the next aspiration step.
5. Press the actuate key again.
The display then shows:
6. Hold the Combitip over the tube into which the liquid is to be dispensed.
7. Press the actuate key to dispense the liquid.
After dispensing, the following is shown temporarily in the display:
8. Remove the Combitip.
5.8 Pipetting
1. Prepare the Multipette stream/Repeater stream.
2. Immerse the Combitip into the liquid to be aspirated.
3. Press the actuate key to aspirate the liquid.
The display shows:
If you only wish to dispense a volume once,
use of the
Pip mode is recommended. The
Pip mode can also be used to mix a solution
by repeated aspirating and dispensing. If a
solution must be dispensed at low speed in
the
Dis mode, but quickly mixed before,
this can be accomplished by combining
these two modes.
Press key for
special step
next step
Discard
Release
Combitip now
1 2
next step
Discard