Eppendorf 2150 Digital Platform Shaker - Manual (Page 13)

Product description
New Brunswick Digital Platform Shaker Innova® 2100/2150
English (EN)
13
3.4.2 Keypad
3.4.3 Status indicators
3.4.4 Function indicators
3.5 Platform assemblies
Neither the Innova 2100 nor the 2150 can be used without a platform. One must be purchased and installed
on your shaker prior to operation (see
Platforms on p. 31).
The Innova 2100 can be used with a wide range of New Brunswick 28 cm x 33 cm (11 in × 13 in) platforms,
which will accept a variety of clamps for flasks, test tubes, etc.
The Innova 2150 can accommodate an even wider range of New Brunswick 30.5 cm × 40.6 cm (12 in x
16 in) platforms, which will accept a variety of clamps for flasks, test tubes, etc.
START/STOP • Starts and stops the drive
• Activates or stops timer when timed run is desired
Keys • Adjusts the setpoint of a displayed parameter up or down
• Used to enter the SET mode for setpoint changes
SELECT • Changes the displayed parameter
• Temperature (°C) cannot be selected unless the temperature/remote monitoring
option is installed.
MAINT • Illuminates after 10000 hours of use. Indicates need for routine maintenance (see
Routine maintenance on p. 25)
SET Illuminates to indicate that:
• Shaker is in SET mode
• Setpoints are being displayed
• Setpoints can be altered
TIME • Illuminates to indicate that the timer is in operation
MUTE • Illuminates to indicate that the audible alarm is disabled
RPM Revolutions per minute shaking speed
HRS Time remaining
°C Temperature function (only activated of the temperature/monitor option is installed)
* This function is not active in the Innova 2100/2150