JLG 1200SJP Operator Manual - Manual (Page 58)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-18 – JLG Lift – 3121141
5. Tilt Alarm Warning Light and Alarm
Indicates that the chassis is on a slope. An alarm will also
sound when the chassis is on a slope and the boom is above
transport position. If lit when the boom is raised or
extended, retract and lower to below horizontal then re-
position machine so that it is level before continuous opera-
tion. If the boom is above transport position or telescoped,
out and the machine is on a slope, the tilt alarm warning
light will illuminate and an alarm will sound and CREEP is
automatically activated.
IF ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED, RETRACT AND LOWER TO
BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT IT IS LEVEL BEFORE
EXTENDING BOOM OR RAISING BOOM more than 15 degrees ABOVE HORIZONTAL.
6. Glow Plug Indicator
Indicates the glow plugs are operating. After turning on igni-
tion, wait until light goes out before cranking engine.
7. Footswitch/Enable Indicator
To operate any function, the footswitch must be depressed
and the function selected within seven seconds. The enable
indicator shows that the controls are enabled. If a function is
not selected within seven seconds, or if a seven second lapse
between ending one function and beginning the next func-
tion, the enable light will go out and the footswitch must be
released and depressed again to enable the controls.
Releasing the footswitch removes power from all controls
and applies the drive brakes.
TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE THE FOOTSWITCH
BY BLOCKING OR ANY OTHER MEANS.
FOOTSWITCH MUST BE ADJUSTED IF FUNCTIONS ACTIVATE WHEN SWITCH ONLY
OPERATES WITHIN LAST 1/4" OF TRAVEL, TOP OR BOTTOM.