JLG 150HAX Operator Manual - Manual (Page 51)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121213 – JLG Lift – 3-15
Auxiliary power is primarily intended for platform lowering
in the event of primary power failure. However, auxiliary
power may be used for platform positioning when operat-
ing in close quarters in the following sequence:
a. Position PLATFORM/GROUND switch to PLAT-
FORM.
b. Position IGNITION/EMERGENCY STOP switch to
ON.
c. Depress and hold footswitch.
d. Operate appropriate control switch or lever for
desired function and hold.
e. Position AUXILIARY POWER switch to ON and hold.
f. Release AUXILIARY POWER switch, selected con-
trol switch or lever, and footswitch.
g. Position IGNITION/EMERGENCY STOP switch to
OFF.
24. Platform Overload (If equipped)
Indicates the platform has been overloaded.
25. Intercom (Not Shown)
The machine is equipped with an intercom system that
permits the operator in the platform to communicate
with personnel on the ground. The platform intercom is
located to the right of the platform control console, and
is attached to the platform rail. The ground intercom is
located on the right front side of the machine turntable.
26. Platform Receptacle (Not Shown)
A dual 110 Volt receptacle is located on the right side of
the platform control console. The receptacle is con-
nected either to a plug located on the right front of the
machine turntable that can be connected to 110 Volt
power, or, if equipped, to a 110 Volt generator on the
machine. The purpose of the platform receptacle is to
permit the operator to operate power tools in the plat-
form.