JLG 260MRT Operator Manual User Manual

Page 35

Advertising
background image

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL

3121219

– JLG Lift –

3-3

6. Glow Plug Switch - A momentary contact, push button

type switch that supplies electrical power to the engine’s
glow plugs, when depressed, to assist cold starting.

7. Water Temperature LED - Illuminates when engine water

temperature becomes overheated.

8. Charge Pressure - Illuminates when the charge pressure

drops below 70 psi (4.8 bar), indicating the charge filter
is clogged and needs to be replaced. The indicator is
also connected to a temperature sensor to prevent false
signals from being generated when the hydraulic oil is
below normal operating temperature.

9. Lift Switch - A three position, momentary contact Lift

control switch provides raising and lowering of the plat-
form when positioned to up or down.

10. Hourmeter -The machine may be equipped with an

hourmeter to indicate the number of hours the machine
has been operated.

11. Ignition/Emergency Stop Switch - A two-position, red,

mushroom-shaped ignition/emergency stop switch,
when positioned to ON with the power selector switch
positioned to ground, furnishes operating power to the
ground control station. In addition, the switch can be
used to turn off power to the function controls in the
event of an emergency. Power is turned on by pulling

the switch out (on), and is turned off by pushing the
switch in (off).

12. Start Switch - A momentary contact, push button type

switch that supplies electrical power to the starter sole-
noid when the emergency stop switch is in the ON posi-
tion and the start button is depressed.

13. Platform Overload LED (If Equipped) - Indicates the plat-

form has been overloaded. An audible alarm will also
signal when the platform is overloaded.

NOTE: If the Overload Indicator is illuminated, all functions will be

prevented from the platform controls. Using the ground
controls or manual descent, fully lower the machine and
reduce the weight in the platform so as to not exceed the
rated workload indicated on the capacity decal.

Advertising