JLG 1100S Service Manual User Manual

Page 293

Advertising
background image

SECTION 6 - JLG CONTROL SYSTEM

3121256

– JLG Lift –

6-19

DRIVE:
11
(1100S Only)

0

1

2WD: 2 Wheel Drive installed.

4WD: 4 Wheel Drive installed.

0

SOFT TOUCH:
12

0

1

NO: No soft touch system installed.

YES: Soft touch system installed.

0

GEN SET/WELDER:
13

0

1

2

NO: No generator installed.

BELT DRIVE: Belt driven setup.

HYDRAULIC DRIVE: Hydraulic driven setup.

1

GEN SET CUTOUT:
14*

0

1

MOTION ENABLED: Motion enabled when generator is ON.

MOTION CUTOUT: Motion cutout in platform mode only.

0

* Only visible if Gen Set / Welder Menu selection is not 0.

H & T LIGHTS:
15

0

1

NO: No head and tail lights installed.

YES: Head and tail lights installed.

0

LOAD SYSTEM:
16*

0

1

2

3

4

NO: No load sensor installed.

WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2
sec OFF).

CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5
sec ON, 2 sec OFF).

CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), plat-
form alarm beeps (5 sec ON, 2 sec OFF).

SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out & main
lift up, platform alarm beeps (5 sec ON, 2 sec OFF).

0

* Only visible under certain market selections.

* Certain market selections will limit load system options or alter default setting.

Table 6-2. Machine Configuration Programming Information

Configuration Digit

Number

Description

Default

Number

Advertising
This manual is related to the following products: