JLG 15VPSP Operator Manual - Manual (Page 41)

SECTION 5 - OPTIONAL EQUIPMENT
3120796 – JLG Lift – 5-1
SECTION 5. OPTIONAL EQUIPMENT
5.1 OPTIONAL EQUIPMENT
The VPSP Series models are available with the following
optional equipment:
Lifting Hook
The optional lifting hook is mounted at the top rear of the
first mast section. The hook is used to lift the machine up
or down to another level.
Horn
The horn is activated by the horn pad on the platform con-
troller box. It can be used at the descretion of the operator
to alert other personnel to the presence of the machine.
Obstruction Sensing System
The Obstruction Sensing System (OSS) is designed to
detect the presence of obstructions directly under the
platform which are present in it’s detection zone. The OSS
is intended as a supplemental system. It remains the oper-
ator's responsibility to watch for obstructions under and
around the machine at all times. See Section 5.2, Obstruc-
tion Sensing System (OSS) for complete detailed descrip-
tion.
Rug Carrier Accessory
The Rug Carrier Accessory consists of two pivoting arms
mounted to the 15VPSP platform left side rails. The pivot-
ing arms are locked in the plane of the platform side rail
when not in use (the stowed position). The arms are
locked into position at approximately 90 degrees to the
left side platform side rails when in use (the carry posi-
tion). The pivoting arms’ position can be changed by lift-
ing each arm to release the lock, rotating the arm, and
lowering each arm back into a locked position.
NOTE: The Rug Carrier accessory is available only on the
JLG model 15VPSP and not authorized for use with
any other JLG lift. The Rug Carrier Accessory is
intended for use in hanging and removal of rugs in
hanging display racks only. Use for any other pur-
pose is not authorized by JLG.
See Section 5.3, Rug Carrier Accessory for complete
detailed description and operation.
Programmable Security Lock (Keyless)
This keyless PSL
tm
Programmable Security Lock switch
features a numbered keypad where a four (4) digit code
must be entered before machine operation can begin.
This allows controlled access to a machine so only those
persons with the Operator’s Code can power a machine
up and operate it.
See Section 5.4, Progammable Security Lock (PSL™) for
complete detailed description and operation.