JLG TF6-42 (9150-4003) Operator Manual - Manual (Page 39)

Form No. 20136 3/03 • TF6-42 Owner/Operator Manual
Other Attachment Capacities
A serial number/capacity plate is attached to all JLG/GRADALL-furnished
attachments. Do not assume that any JLG/GRADALL attachment may be
used on any JLG/GRADALL Material Handler.
First, check the listing of approved attachments on handler serial number
plate. If the attachment in question is not included in the list, contact your
local JLG/GRADALL Distributor to check whether or not the attachment is
approved.
Next, if the attachment is approved for use with your handler, compare
maximum capacity from attachment serial number plate and value stamped
on forks to maximum capacity for that attachment as indicated on material
handler serial number plate. The smallest of these values is correct for
your handler
Attachment Operation
Operation of the handler equipped with carriage/fork combination is covered in
the GRADALL Material Handler Safety Manual and this Manual.
Operation of the handler when equipped with other approved attachments is
covered in this section or in separate instructions furnished with the attachment.
Any separate instructions must be kept in Manual Holder in cab with this Owner/
Operator Manual, an additional copy must be kept with the attachment if it is
equipped with a manual holder.
Operate a handler equipped with an attachment as a partially-loaded handler.
Pay special attention to capacity and range limits for the handler/attachment
combination.
Practice operation of handler and attachment in a safe, open area, not hazardous
to yourself, other persons, equipment or property. Become thoroughly familiar
with response of handler and attachment to controls before operating in a work
situation.
Always consider terrain between present location of load and delivery point.
Never attempt to transport a load across terrain which could cause handler to tip
over.
15.1
Never use an attachment without
the appropriate, JLG/GRADALL
supplied capacity chart for that
particular attachment installed
on the handler.
WARNING !
ATTACHMENTS