JLG G12-55A Parts Manual - Manual (Page 34)

BOOM
G10-55A, G12-55A 31200728 2-10
Figure 2-3 Second Boom Section
PAL6380
102
201
103
140
147
201
99
53
60
87
63
100
138
139
201
99
45
67
64
57
54
65
65
47
82
97
117
201
101
201
88
2
52
61
62
78
137
201
99
63
60
55
78
134
201
99
98
111
201
67
64
56
82
78
100
138
139
201
83
96
97
117
141
147
201
13
90
201
2
G12-55A
Note: Wear Pad Shimming:
Whenever a shim is used with a pad, a spacer with holes must be inserted between pad & shim.
The wear pad or wear pad insert must not sit directly on the slotted surface of shims.
Add wear pad shims & spacers as required to shim boom to maintain a total minimum gap of 0.070 to 0.130 in (1,8 to 3,3 mm) in
both horizontal & vertical directions.
Wear pad bolts require one hardened washer. However, up to (2) hardened washers may be used except where noted otherwise.
Under no circumstances should more than (2) hardened washers ever be used.
The length of pad bolts depends on the number of the shims used. The bolt cannot extend past chamfer on wear pad.
Add Mystik Tetrimoly Grease (14404793) to all wear pads & all wear pad slide pathways. If applicable, this includes all pad grease
fittings at the rear of boom.