Trip and fall hazards, Trip and fall hazards -4 – JLG 860SJ Operator Manual User Manual

Page 14

Advertising
background image

SECTION 1 - SAFETY PRECAUTIONS

1-4

– JLG Lift –

3121630

• Do not carry materials directly on platform railing unless

approved by JLG.

• When two or more persons are in the platform, the operator

shall be responsible for all machine operations.

• Always ensure that power tools are properly stowed and never

left hanging by their cord from the platform work area.

• When driving, always position boom over rear axle in line with

the direction of travel. Remember, if boom is over the front
axle, steer and drive functions will be reversed.

• Do not assist a stuck or disabled machine by pushing or pull-

ing except by pulling at the chassis tie-down lugs.

• Fully lower platform and shut off all power before leaving

machine.

• Remove all rings, watches, and jewelry when operating

machine. Do not wear loose fitting clothing or long hair unre-
strained which may become caught or entangled in equip-
ment.

• Persons under the influence of drugs or alcohol or who are

subject to seizures, dizziness or loss of physical control must
not operate this machine.

Trip and Fall Hazards

• During operation, occupants in the platform must wear a full

body harness with a lanyard attached to an authorized lanyard
anchorage point. Attach only one (1) lanyard per lanyard
anchorage point..

• Enter and exit only through gate area. Use extreme caution

when entering or leaving platform. Ensure that the platform
assembly is fully lowered. Face the machine when entering or
leaving the platform. Always maintain “three point contact”
with the machine, using two hands and one foot or two feet
and one hand at all times during entry and exit.

Advertising
This manual is related to the following products: