JLG 2658E3 Operator Manual - Manual (Page 25)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3120877 – JLG Sizzor – 3-5
motor. Do not try to operate the drive, lift, and pow-
ered deck extension functions simultaneously. If the
drive, lift, and powered deck extension functions are
selected simultaneously, no function will operate. If
this occurs, pause, then press only one of the func-
tion switches to activate the function.
NOTE: If the machine is equipped with the optional powered
deck extension, the drive function is cut out when the
deck is extended with the platform raised above the
stowed position.
As an option, Models 2033E3 and 2646E3 may be
equipped for 450 kg. platform capacity. When
equipped for 450 kg. platform capacity, Model
2033E3 cuts out the drive function at a platform
height of 5.2 m and Model 2646E3 cuts out the drive
function at a platform height of 5.8 m.
The machine is equipped with a Pothole Protection
System which lowers automatically when the plat-
form is raised. If the Pothole Protection System does
not fully lower, the drive function is cut out until the
platform is completely lowered.
7. High Drive Speed Switch - The high drive speed
switch, when used in conjunction with the joystick
being operated in the drive mode, provides addi-
tional oil flow to the drive circuit for increased travel
speed. To operate high drive, depress the high drive
speed switch either simultaneously with the drive
switch or while operating the drive function.
DO NOT USE HIGH DRIVE SPEED WHEN DRIVING IN CLOSE
QUARTERS OR WHEN DRIVING IN REVERSE.
IF HIGH DRIVE IS SELECTED WHEN OIL TEMPERATURE IS VERY
COLD (BELOW 4.4 DEGREES C.) HIGH DRIVE WILL NOT ENGAGE
IMMEDIATELY. AS OIL WARMS (ABOVE 4.4 DEGREES C.) IF HIGH
DRIVE IS SELECTED, IT WILL ENGAGE AUTOMATICALLY WHILE
DRIVING.
NOTE: The High Drive Speed switch will cut-out when the
platform is raised above the stowed position, return-
ing drive speed to low until the platform is lowered
completely.
DO NOT OPERATE MACHINE IF HIGH DRIVE SPEED OPERATES
WHEN PLATFORM IS RAISED ABOVE THE STOWED POSITION.
Figure 3-3. Platform Control Station - All Models