I.R.I.S. IRIScan Anywhere 3 Quick Start - Manual

En
gli
sh
This Quick User Guide helps you install and get started with the IRIScan™ Anywhere 3
scanner.
The software delivered with this scanner is:
- Readiris™ Pro 14 and Cardiris™ Pro 5 (for Windows®)
- Readiris™ Pro 14 and Cardiris™ Pro 4 (for Mac® OS)
For detailed information about Readiris™’ and Cardiris™’ full range of features, consult
the help file provided with the software, or the latest User Guides on www.irislink.com/
support/userguides.
The descriptions in this guide are based on the Windows 7 and Mac OS Lion operating
systems. All information is subject to change without prior notice.
Table of Contents
1. Using the IRIScan™ scanner
2. Software Installation on a Windows PC
2.1 Using Readiris™
2.2 Using Cardiris™
3. Software Installation on a Mac OS computer
3.1. Using Readiris™
3.2 Using Cardiris™
4. IRIScan™ Scanner Reference Information
5. FAQ and Technical Support
1. Using the IRIScan™ scanner
Before you begin: charge your scanner for 4 hours.
1. Turn on your computer.
2. Connect the scanner to your computer using the USB cable.
3. The orange light is on while charging.
4. When the scanner is fully charged the orange light goes out. Then disconnect
your scanner from the computer.
Preliminary note:
The IRIScan™ scanner is designed to be used on its own, disconnected from any computer. The
documents you scan are stored in the scanner’s internal memory (or optional SD card / USB
flash drive). From there they can be loaded into Readiris™ and Cardiris™.
So, note that the IRIScan™ is not a Twain-based scanner that can be used from within any
application to scan documents. Instead, think of it as a USB storage device that is able to scan
independently.
Scanning documents:
STEP 1 : Press the power button for a moment.
• The green light blinks a few seconds then remains on.
• The scanner is now ready.
Refrain from scanning documents while the green light is blinking!