Step 4: mounting the receiver to a wall (optional) – IOGear GWHDMS52 User Manual
Page 15
Advertising
15
Step 4: Mounting the Receiver to a Wall (Optional)
1. Refer the drawing at right that has relative
position of the main holes that will be
needed to be drilled into the wall.
2. Drill two 1/4” pilot holes.
3. Insert the supplied two Anchors into
the wall. If necessary, use a small
hammer to lightly tap the anchors flush
to the wall.
4. Insert two screws into the anchors.
Leave 1/4” length for mounting the
Transmitter, 5/8” for the Receiver.
5. Place receiver main holes over the
protruding screws and slide down into
position.
Advertising