Echo CH8670H Owners Manual v.5 - Manual (Page 12)

8 8 INCH TURNTABLE CHIPPER
ASSEMBLY
2.9 add oIL To ENGINE
2.8 chEck/add hYdRauLIc FLuId
2.11 FILL ThE TaNk
gasoline and diesel fuels are highly flammable
and their vapors are explosive. to prevent
personal injury or property damage:
Store fuel only in approved containers, in well
ventilated, unoccupied buildings, away from sparks
or flames. A container with a capacity of 2 gallons or
less with a pouring spout is recommended. Do not fill
the fuel tank while the engine is hot or running, since
spilled fuel could ignite if it comes in contact with hot
parts or sparks from ignition. Do not start the engine
near spilled fuel. Never use fuel as a cleaning agent.
DO NOT MIX OIl WITH FuEl.
daNGER
Check the oil level and, if needed, fill the engine crankcase
with the type and amount of oil specified in the engine
owner’s manual.
Hydraulic fluid drives the feed roller. The machine was
shipped with fluid, as it was tested at the factory. However,
check the fluid levels before initial operation and add if
necessary.
The hydraulic pump requires premium hydraulic fluids
containing high quality rust, oxidation, and foam inhibitors.
These include premium turbine oils, API CD engine oils
per SAE J183, M2C33F or g automatic transmission
fluids meeting Allison C-3 or Caterpillar TO-2, and certain
specialty agricultural tractor fluids.
use only those types of fuels that are recommended in
your engine owner’s manual.
To add fuel:
Stop engine, wait for all parts to stop moving and 1.
disconnect spark plug wire. Remove key from key
switch. Allow the engine and muffler to cool for at least
three minutes.
Clean area around fuel fill cap and remove cap.
2.
using a clean funnel, fill fuel tank to 1/2” below bottom 3.
of filler neck to provide space for any fuel expansion.
Install fuel fill cap securely and wipe up any spilled
gasoline.
2.10 coNNEcT ThE baTTERY
you will need to purchase a battery. Choose a battery that
meets or exceeds the engine manufacturer’s specifications.
Consult your engine owner’s manual or authorized dealer
for specification details.
To install the battery:
Open the battery box and insert battery into the battery 1.
box.
Attach the positive (red) battery cable from the engine
2.
to the positive (+) battery terminal.
Attach the negative (black) battery cable from the
3.
engine to the negative (-) battery terminal.
Secure the cover on the battery box with the strap.
WaRNING
To avoid sparks and a possible explosion or fire due
to a short circuit, do not touch the positive (+) battery
terminal and any surrounding metal with tools, jewelry
or other metal objects. When installing battery cables,
connect the positive (+) cable first and the negative (-)
cable last.
2.7 chEck REaR RoLLER WhEELS
After the chipper is fully assembled, check the rear roller
wheels to make sure they are touching the turntable base
that is directly above them. If there is a gap, the wheels
will not adequately support the trailer base. To adjust the
wheels, see Sec. 5.16.
REAR ROLLER
WHEELS
TURNTABLE
BASE
Figure 2.5 - Rear roller wheel adjustment