Echo CH8670H Owners Manual v.3 - Manual (Page 10)

6 TURNTABLE CHIPPER
aSSEmbLY
WaRNING
Mount tires and rims to the axle using the lug nuts. 1.
Attach the fender supports to the trailer using three 2.
1/2" x 3-1/2" hex bolts, washers & nuts.
Attach the fenders to the fender supports using four
3.
3/8" x 1" carriage bolts, washers and nuts.
EuRopEaN modELS:
thread the wire harness through the hitch tube and 1.
slide the hitch tube into the trailer frame. Secure using
two 1/2" x 4-1/2" bolts, washers and nuts (provided in
owner's kit).
Slide the hitch coupler onto the hitch tube from the top
2.
and secure using 1/2" bolts, nuts and washers.
thread the wire harness through the metal loop on the
3.
underside of the coupler.
2.3 REaR STabILIzER
Verify that the rear stabilizer is installed. To install the
rear stabilizer, slide the stabilizer into the corresponding
bracket beneath the rear of the chipper frame. Adjust the
stabilizer and secure with the provided snap pin.
NoN EuRo modELS:
thread the wire harness through the hitch tube and slide
the hitch into the trailer frame. Secure using two 1/2" x
4-1/2" bolts, washers and nuts (provided in owner's kit).
2.4 add oIL To ENGINE
Section
2.5 chEckING/addING hYdRauLIc FLuId
2
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
Check the oil level and, if needed, fill the engine crankcase
with the type and amount of oil specified in the engine
owner’s manual.
Hydraulic fluid drives the feed roller. The machine was
shipped with fluid, as it was tested at the factory. However,
check the fluid levels before initial operation and add if
necessary.
The hydraulic pump requires premium hydraulic fluids
containing high quality rust, oxidation, and foam inhibitors.
These include premium turbine oils, API CD engine oils
per SAE J183, M2C33F or g automatic transmission
fluids meeting Allison C-3 or Caterpillar TO-2, and certain
specialty agricultural tractor fluids.
2.1 TIRES aNd RImS
2.2 TRaILER hITch