Black & Decker JS670V - Manual (Page 10)

10
Highlighter Pen Storage (figure I)
- The highlighter marking pen (15) stores in
the pen holder (16).
- The pen holder (16) can be opened and
attached anywhere on the cord (21) as shown
in figure I.
- To move the pen holder, unlock the hinge
and open the holder.
- Remove from cord and place anywhere up
or down the cord.
NOTE: Should you need to replace the
highlighter marking pen (15) it can be
replaced with a standard yellow highlighter
found at office supply stores (fine tip
recommended).
Connecting a vacuum cleaner to the tool
A hose adaptor (not supplied) is available at extra cost through your nearest Black & Decker
service center. Insert the hose adaptor into the opening at the back of the saw. Connect a
vacuum cleaner hose (not supplied) to the hose adapter.
Rip & Circle Cutting
Ripping and circle cutting without a pencil line
are easily done with the rip fence and circle
guide (available at extra cost).
Using the screw supplied with the accessory
guide, position as shown in figure J and
thread the screw into the shoe to clamp the
fence securely.
When circle cutting, adjust rip fence so that
distance from blade to hole in cross bar is at
the desired radius and tighten screw. Place
saw so that hole in cross bar is over center of
circle to be cut (drill hole for blade or cut
inward from edge of material to get blade into
position). When saw is properly positioned,
drive a small nail through hole in cross bar.
Using rip fence as a pivot arm, begin cutting
circle. For circle cutting, the cross bar should
be up, as shown in figure J.
When ripping, slide the rip fence under the
screw from either side of the saw. Set the
cross bar at desired distance from blade and
tighten screw. For ripping, the cross bar
should be down and against the straight edge
of the workpiece as shown in figure K.
I 16
15
21
K
J