Echo CH8670H Owners Manual v.2 - Manual (Page 18)

14 TURNTABLE CHIPPER
OPERATION
4.10 ToWING
S & F modELS:
hookING
Rotate the discharge tube to face the opposite direction 1.
of the towing vehicle before towing.
Insert transport safety pin and clip, and set turntable
2.
brake handle to locked position.
Raise rear stabilizer.
3.
open the coupler latch. 4.
raise the trailer hitch until the coupler is above the 5.
height of the hitch ball (51 mm hitch ball) on the towing
vehicle.
align the coupler over the hitch ball and lower the trailer
6.
hitch until the coupler fully engages the hitch ball.
Close the coupler latch securing the coupler to the hitch
7.
ball.
Connect the wire harness into the tow vehicle.
8.
Raise the jack stand and secure to the hitch. 9.
uNhookING
Disconnect the wire harness from the tow vehicle. 1.
unlatch the coupler and disconnect the hitch coupler 2.
from the hitch ball.
Move the hitch of the chipper away from the hitch ball,
3.
lower the jack stand and secure.
lower rear stabilizer.
4.
domESTIc modELS:
hookING
Rotate the discharge tube to face the opposite direction 1.
of the towing vehicle before towing.
Insert transport safety pin and clip, and set turntable
2.
brake handle to locked position.
Raise rear stabilizer.
3.
open the coupler latch. 4.
raise the trailer hitch until the coupler is above the 5.
height of the hitch ball (2" hitch ball) on the towing
vehicle.
align the coupler over the hitch ball and lower the trailer
6.
hitch until the coupler fully engages the hitch ball.
Close the coupler latch securing the coupler to the hitch
7.
ball.
install the hitch pin through the coupler latch.
8.
Cross the safety chains under the hitch and connect 9.
Optimum towing performance can be achieved by
maintaining a horizontal trailer hitch.
NoTE
Return chipper to transport position, insert transport
safety pin and clip, and set turntable brake handle to
locked position. Failure to do so may result in damage
to the machine and/or serious bodily injury.
WaRNING
to towing vehicle.
Connect the wire harness to the tow vehicle.
10.
Raise the jack stand and secure to the hitch using a 11.
hitch pin.
uNhookING:
unhook the safety chains from the towing vehicle. 1.
latch safety chains to the hitch to prevent them from
interfering with chipping.
Disconnect the wire harness from tow vehicle.
2.
Remove the hitch pin from the coupler latch. 3.
unlatch the coupler and disconnect the hitch coupler 4.
from the hitch ball.
Move the hitch of the chipper away from the hitch ball
5.
and lower the jack stand. Secure with a hitch pin.
lower rear stabilizer.
6.