Echo 76624 Instruction v.2 - Manual

Instruction Sheet
Instructions
PN 76197-00
Rev. 111108
SUBJECT: SAFETY BAR FOR 6-
INCH CHIPPER WITH PLUS 1
CONTROLLER KIT # 76196-00
FITS MODELS: CH6670H (76624),
CH611DH (76628), CH6993H (76635)
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect the
battery cables and make sure all moving parts have
come to a complete stop.
WARNING
These instructions will describe how to install the safety
bar kit on 6 Inch Chippers.
REMOvE ExISTING TRAy
Remove the existing tray by taking off the 3/8" bolts that
hold the tray onto the chipper chute.
INSTALL SAFETy BAR
Put the coated clamp in the center bolt hole of the 1.
hinge and pivot bar. The coated clamp must be placed
behind the hinge and pivot bar.
When installing the coated clamp, run the wire harness
from the kneebar switch through the clamp.
NOTE
Bolt on the new tray with knee bar using the hardware 2.
removed from the old tray. Adjust the tray by lifting it
up in the closed position. Make sure it locks in place
when it is in the upright position.
COATED CLAMP
PUTTING THE NEW TRAY ON THE CHUTE
Paying attention to the order when removing the old parts
will aid in installing the new parts in the correct order.
NOTE