Echo HEDGE TRIMMERS SAFETY MANUAL - Manual (Page 25)

25
•
NEVER test for ignition spark by grounding spark
plug near cylinder plug hole. A spark could ignite
fuel vapor, causing serious injury from explosion or
fire.
•
NEVER use a unit with broken, damaged, missing,
or worn parts. Contact your dealer for repairs if
problems are found.
•
NEVER use substitute parts, parts from other mod-
els or brands, or used parts, when performing
maintenance or repairs. Use only new parts that are
manufactured for your specific serial number and
model of hedge clipper.
•
NEVER make temporary repairs on a unit - taking
shortcuts or using questionable parts and perform-
ing repairs that are not approved by Echo may
create a safety hazard that can cause serious injury.
Improper repair may also cause premature part
failures, and void your product warranty.
•
ALWAYS keep hedge clipper blades sharp. Cutting
with dull blades increases the chances of jams,
reduces cutting efficiency, and increases operator
fatigue.
•
ALWAYS keep hedge clipper blades properly
adjusted. Improperly adjusted blades may result in
poor cutting performance, increased risk of jams,
and premature blade wear or failure.
•
ALWAYS keep blades and gear case properly
lubricated. Poor lubrication can cause result in part
failures and cause overheating.
•
ALWAYS keep fasteners tightened securely. Op-
eration with loose fasteners can result in hazardous
operation.
•
ALWAYS perform a safety check after performing
any service or maintenance on the unit. Make sure
all parts have been properly installed, all hardware is
properly tightened, and all guards and shields are in
place.
MAINTENANCE