Bosch Slim-Grip SM515 - Manual (Page 2)

SM515 |
Slim-Grip™ Universal Holder with Mini Windshield Suction and Dashboard Mount
Choose a suitable location for disc (and pedestal) installation.
Do not place mount in or near an air bag deployment zone
or where it will obstruct view of the road or hinder vehicle
operation.
Clean the dashboard or console surface area thoroughly with
the included alcohol pad. Allow the area dry before applying
the mounting disc.
Remove the paper backing of the disc and place on the
cleaned surface. Press the top of the disc down fi rmly to allow
the adhesive to stick to the surface. Allow 24 hours for the
adhesive to cure to the surface before applying any pressure.
Step 1.
Step 2.
Step 3.
Dashboard or Console Mounting Instructions
Place the suction cup of the pedestal fi rmly down on the center
of the mounting disc and lower the securing lever. Step 4.
Push the pedestal suction cup (A) down onto the disk (C). Flip the
lever (B) down to secure the suction cup. Adjust the angle of the
pedestal head as needed. Step 5.
A
B
C
!
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or
air bag deployment.
Arkon is not responsible for any damages caused to your car, your
device, or yourself due to the installation or use of this pedestal mount.
Adjusting Holder to Fit Phone
E
E
If necessary, adjust the support legs (E) on top and bottom by
sliding them laterally to avoid any buttons or ports that may be
on your phone. Step 1.
Continued in
next column...
Consumer Hotline:
USA (800) 841-0884
INT’L (626) 254-9005
Monday - Friday 9 am - 5 pm, PST
Designed in USA | Made in China And Taiwan
© Copyright 2010 Arkon Resources, Inc.
www.arkon.com
Arcadia, CA 91006 USA
Representative in KOREA
www.knctek.com
TEL : 02) 839-5701
FAX : 02) 830-5703
࣬ ৹ࢄߔ޺੦