Service and maintenance, 10 troubleshooting – Echo 73040 Owners Manual v.2 User Manual

Page 17

Advertising
background image

Page 13

EZ Trim Mower Owners Manual

Problem

Probable Cause

Suggested Remedies

Broken off or damaged belts

Replace belts

Broken spindle

Repair spindle

Failed bearings

Repair bearings

Cutting string is too weak

Replace with heavier cutting string
(.155)

Growth is too thick or heavy

Reduce trimming area by half or raise
the trimmer head off the ground

Engine not running at full RPM

Speed up engine to full throttle

Cutting string is too weak

Replace with heavier cutting string
(.155)

Drive belts are loose or worn

Replace drive belts

Growth is too thick or heavy

Reduce the size of trimming area in
half or raise the trimmer head off the
ground slightly

Belts too tight

Move spindle hub assembly towards
the rear of the trimmer

Drive belts are loose or worn

Replace drive belts

Worn or damaged pulley

Replace pulley

Gas tank is empty

Fill gas tank

Spark plug wire is disconnected

Connect loose wire to the spark plug

Spark plug is defective

Replace spark plug

Gas line is obstructed (bail
disconnected)

Remove gas line at carburetor and
check for obstruction. Drain gas tank
and refill with fresh gasoline.

Dirty, stale, water-contaminated gas

Drain tank and fill with fresh gasoline

Flooded engine

Put throttle control in run position and
crank engine several times to clear
out excess gas

Dirty or plugged air cleaner or engine
cooling fins

Clean air cleaner or replace. Clean
cooling fins and shroud area of
engine.

Engine brake control open

Replace engine brake control

Pulley not aligned

Align pulleys

Belt not tensioned properly

Tension belt with 70 lbs of force

Spindle bearing failed

Replace bearing

Loose chain

Tighten chain

Worn chain

Replace chain

Worn sprocket

Replace sprocket

Sprocket not aligned

Align drive sprocket and wheel clutch
assembly with washers

Engine won't start or is

hard to start

Drive belt rolling or falling

off of pulleys

Chain Falling off Self

Propelled Model

Cutting strings do not

turn

Cutting is slow or rough

Trimmer requires

excessive power or stalls

Drive belts squealing or

smoking

Service and Maintenance

4.10 TROUBLESHOOTING

Advertising