BLACKHAWK! BH6010 - Manual (Page 3)

SAVE THESE INSTRUCTIONS
For your safety, read, understand, and follow the information provided with and on this jack. The owner and operator of this
equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The owner and
operator shall be aware that use and repair of this product may require special skills and knowledge. Instructions and safety
information shall be conveyed in the operator's native language before use of this jack is authorized. If any doubt exists as
to the safe and proper use of this jack, remove from service immediately.
Inspect before each use. Do not use if there are broken, bent, cracked, or damaged parts (including labels). Any jack that
appears damaged in any way, operates abnormally or is missing parts, shall be removed from service immediately. If the
jack has been or suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it),
immediately discontinue to use until jack has been inspected by a Blackhawk authorized service center. It is recommended
that an annual inspection be done by qualified personnel. Labels and Operator's Manual are available from manufacturer.
PRODUCT DESCRIPTION
Blackhawk Long Chassis Hydraulic Service Jacks are designed to lift, but not sustaining, up to rated capacity loads. They
are designed to be used in conjunction with jack stands. Intended use: To lift one wheel or one axle of a vehicle for the
purpose of service and/or repair of vehicle components. After lifting, loads must be immediately supported by appropriately
rated jack stands. Check with vehicle owner's manual for proper lift points.The air actuated unit requires at least 7.8 CFM @
90 - 175 PSI.
DO NOT USE TO DOLLY OR MOVE VEHICLE.
DO NOT USE FOR ANY PURPOSE OTHER THAN THOSE USES OUTLINED ABOVE !
3
SAFETY INSTRUCTIONS
BEFORE USE
1. Verify that the product and the application are compatible, if in doubt call Blackhawk Automotive Technical Service
(816)891-6390.
2. Read the operator's manual completely and familiarize yourself thoroughly with the product, its components and
recognize the potential hazards associated with its use before using this product.
3. Secure the handle into the handle sleeve by means of the bolt and lock washer provided. Tighten securely to prevent
accidental removal of handle while in use.
4. Locate and turn the handle knob counterclockwise to open the release valve (no more than 2 full turns).
5. With saddle fully lowered, locate and remove the oil filler plug. This will help release any pressurized air which may be
trapped within the reservoir. Ensure the oil level is just below the oil filler plug hole.
6. Pump 6 to 8 full strokes. Ensure the oil level is within ~ 3/16" from the inner cylinder as viewed from the oil filler hole.
7. Ensure the jack rolls freely, that the pump and release valve operates smoothly, raises and lowers the unloaded
saddle throughout the lift range before putting into service.
8. Replace worn or damaged parts and assemblies with Blackhawk Replacement Parts only. (See Replacement Parts
Section). Lubricate as instructed in Maintenance Section.
9. Model BH6011 is fitted to accept the popular 1/4" PT air nipple. When installing 1/4" PT nipple of your choice, ensure
that thread tape or compound is used when servicing connections. To help ensure trouble free operation, an inline air
dryer and oiler is recommended.
SPECIFICATIONS
Model Capacity Jack Size (L x W x H) Min. Height Max. Height
BH6010 10 Ton 54 3/4" x 20" x 12 3/4" 7" 27"
BH6011 (Air) 10 Ton 54 3/4" x 20" x 12 3/4" 7" 27"