2N VoiceBlue Next v3.6 - Manual (Page 59)

59
2N TELEKOMUNIKACE a.s., www.2n.cz
®
CLIP routing table + CallBack
The table permanently assigns CLIPs to the extensions to which incoming calls are to
be routed automatically and set the CLIP list for the GMS network for which the
CallBack function is enabled.
GSM number (CLIP) – user identification in a GSM/UMTS network.
AutoDial – enable/disable CLIP routing for the selected CLIP.
Dial to VoIP – enter the VoIP destination number for CLIP routing.
Auto CallBack – enable/disable CallBack for the selected CLIP.
Limit – set the maximum call length (in minutes).
Mobility Extension
The table registers the Mobility Extension users.
Name – enter the user name for calling to VoIP.
User – enter the registration user name for VoIP.
Password – enter the registration user password for VoIP.
GSM number (CLIP) – enter the user SIM card CLIP.
Follow me function – enable/disable call forwarding to a mobile user station
(based on CLIP).
SMS at no answer function – enable/disable sending of information SMS on
missed calls.
Ethernet configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in . 2N VoiceBlue Next
®
IP address – the fixed IP address (v4) of the Ethernet 2N VoiceBlue Next
®
interface.
Subnet mask – the subnet mask for the
Ethernet 2N VoiceBlue Next
®
interface.
Note
You are recommended to read the Routing Algorithm for Outgoing
section on p. before setting the LCR table and prefix lists. Calls
Remember to set the tariffs correctly in the GSM outgoing groups
section to make tariff routing work properly.
The maximum count of LCR table records is 256.
Note
Remember to activate the CallBack mode in the GSM incoming groups
window for a proper CallBack function.
The maximum count of CLIP routing table records is 96.
Note
You are recommended to read the Mobility Extension section on page
carefully before using the Mobility Extension function.