Hyundai H-VC1083 - Manual (Page 3)

3
· Do not make attempts to repair the appliance, adjust or replace parts in the vacuum cleaner. When malfunctions happen, contact the authorized service
center for examination, repair, electrical or mechanical adjustment.
· Do not let the cord hang over edges or touch hot surfaces.
· Before you start using the vacuum cleaner, please remove large or sharp objects from the floor in order to prevent the damage of the filter.
CAUTION: Never use the vacuum cleaner without the filters.
Vacuum cleaner assembling
Always remove the plug from the power supply before fitting or removing accessories.
Fitting flexible hose
· Insert the flexible hose into the air inlet and press it until it clicks into proper position.
Hose removing
· To remove the flexible hose from the vacuum cleaner, press the button situated on the flexible hose base, then pull to remove it from the attachment
point.
Fitting telescopic tube and accessories
· Extend the telescopic tube to the desired length by pressing on button.
· Insert a flexible hose into a telescopic tube.
· Open the accessories compartment.
· Fit a nozzle to telescopic tube:
- Floor brush is intended for cleaning bare floor and floor coverings.
- Furniture brush is for cleaning sofa, curtain or dust on the decorating surfaces.
- Crevice/Furniture nozzle is for cleaning sofa, curtain or dust on the decorating surfaces and corners and between cushions.
Instruction for use
· Before using the appliance, unwind a sufficient length of the cord and insert the plug into the power supply. The yellow mark on the cord shows the ideal
cord length. Do not unwind the cord beyond the red mark.
· Press the On/Off button to switch the unit on. To stop it press the On/Off button again.
· You can adjust the air flow using the air flow regulator on the flexible hose:
- decrease power for cleaning curtains, books, furniture, etc.
- increase power for cleaning bare floor.
· You can adjust the vacuum cleaner power using the power control on body.
· To rewind the cord, press the rewind button and guide the cord with hand to ensure that it does not whip causing damage.