ADS-TEC Softkeyboard - Manual (Page 24)

Softkeyboard
24
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
You can change the configuration in the section [VfrontKey] of the SoftKey.ini file.
The options below are available:
Layout: Changes the layout type of Vfrontkey application. Available values are 1, 2
and 3, default value is 1.
1 = Layout 1
2 = Layout 2
3 = Layout 3
MoveTimeout: Timout to start the movement of the VFrontkey application. Any
positive value is possible,
default value is 500.
0…nnnn = Timeout in milliseconds.
Mode: The way of resizing the application. Available values are 0, 1 and 2, default
value is 1.
0 = The size is adapted to the Softkeyboard application. The following three options
are ignored.
1 = The size is determined by the option SizeType. The options SizeWidth and
SizeHeight are ignored.
2 = The size is determined by the options SizeWidth and SizeHeight. The option
SizeType is ignored.
SizeType: Ten pre-defined sizes from 1 (small) to 10 (large), default value is 6.
1…10 = Size types.
SizeWidth: The width of the application from 10 pixels to 380 pixels, default value is
192.
10…380 = Width in pixel.
SizeHeight: The height of the application from 10 pixels to 274 pixels, default value
is 58.
10…274 = Height in pixel.
If VFrontkey is the active application you can change its size with the buttons F11 and
F12. F11 decreases the size of the application down to the minimum value and F12
increases the size of the application up to the maximum value.