AIM Sports Laser Flashlight Combo - Manual (Page 2)

LASER/FLASHLIGHT COMBO
(LFQC01)
CAUTION
Looking directly at laser beam, may cause damage to your eyes.
Keep this product away from children.
CAUTION
Do not over tighten the screws or you may strip the
threaded holes. Stripped holes are NOT covered by warranty.
LH003
Tactical Red Laser
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
FQ150 FEATURES
• Made of anodized aircraft grade aluminum
• Equipped with USA made CREE LED light bulb
• Sliding on/off switch (FQ150 only)
• Weaver style quick release mount
• Includes 3 color filtered lenses
• Fits most full size, compact, or sub-compact pistol frames equipped with an
accessory rail
SPECIFICATIONS
LIGHT BULB
MAX OUTPUT
VOLTAGE
LENGTH
WEIGHT
BATTERY USA CREE LED
150 LUMENS
3W
3.25”
4.2 oz.
CR123A
FQ150
150 Lumens Flashlight
w/Quick Release Mount
FQ150 INSTRUCTIONS
INSTALLING BATTERY
1. Unscrew flashlight head.
2. Install designated battery.
3. Replace flashlight head.
INSTALLING COLOR LENSES
1. Unscrew tip of flashlight head.
2. Replace with desired color lens.
MOUNTING FLASHLIGHT
1. Push down Q/R lever and slide on Picatinny rail.
2. Adjust to the desired position and release the Q/R lever.
LH003 INSTRUCTIONS
LASER SETUP
1. Remove battery cap from top of laser.
2. Put two AG13/LR44 batteries inside of laser with negative facing down and positive
facing up.
3. Replace battery cap.
MOUNTING LASER
1. Loosen the large screw on the side of the laser until laser fits on rail.
2. Tighten screw until laser is secure on rail.
ADJUSTING LASER
1. There are two small screws on the top and side.
2. The top screw controls the elevation. Tighten to move down and loosen to move up.
3. Left to right are adjusted by the screw on the side. Tighten to move to the left and
loosen to move to the right.