AIM Sports Reflex Sights (Special Editions) - Manual (Page 2)

RT4-06C
Reflex Sight w/ Weaver / Picatinny Mount
RT4-06D
Reflex Sight w/ Dovetail Mount
INSTALLING BATTERY
1. Unscrew battery cover and insert new battery, positive side
facing up.
2. Replace battery cover.
MOUNTING REFLEX SIGHT
1. Using Allen wrench, loosen all screws on mount.
2. Place mount on desired mounting platform and evenly tighten
screws.
Do NOT over tighten screws.
3. Because of unlimited eye-relief, you should provide at least
three inches of clearance between the end of the LED & mirror
housing and your eye when shooting.
RETICLES
RT4-01 AND RT4-03
RT4-06C AND RT4-06D
RT4-OE1
RT4-SO1
RT4-WF1
REFLEX SIGHTS
SPECIAL EDITION & MULTI-RETICLE
RT4-01
Reflex Red Dot Sight
RT4-03
Dual-Illuminated Reflex Sight
RT4-OE1
Operator Edition Reflex Sight
RT4-SO1
Special Ops Edition Reflex Sight
RT4-WF1
Warfare Edition Reflex Sight
ARROW DOT 3/4 CIRCLE ARROW DOT
DOT BURST TRI-DOT BIOHAZARD
SKULL SMILEY FACE PREDATOR ARROW DOT
BULLSEYE DOT CROSS STAR BURST
BULLSEYE DOT CROSS STAR BURST
CAUTION
Always check and be certain that the firearm is unloaded
before undertaking any work upon it .
ZEROING
1. Before making any adjustments to your windage and elevation
you must UNLOCK the adjustments.
a. Find the locking screw on the base of the mount.
b. With the small Allen wrench provided, unlock the screw by
backing it off a full turn.
2. Select the reticle you desire by turning the reticle selector knob
and set the intensity at the best position for you.
3. With sight mounted, rest the gun on a solid support and aim at
a target 50 to 100 yards away.
4. Each click adjustment moves the point of impact by 1 MOA
(approximately 1” at 100 yards, 1/2” at 50 yards).
5. Tighten the locking screw to lock your adjustments in place.
Do NOT over tighten screws.
CAUTION
Do not over tighten the screws or you may strip the
threaded holes. Stripped holes are NOT covered by warranty.