AIM Sports 180 Lumens Tactical Flashlights - Manual (Page 2)

CAUTION
Always check and be certain that the firearm is unloaded
before undertaking any work upon it.
FHD180B
180 Lumens Flashlight
(black)
FHD180G
180 Lumens Flashlight
(green)
180 LUMENS TACTICAL FLASHLIGHTS INSTALLING BATTERY
1. Unscrew end cap.
2. Install two CR123A batteries, positive pole first.
3. Replace end cap.
INSTALLING PRESSURE SWITCH
1. Unscrew the bottom cap.
2. Replace with pressure switch.
MOUNTING FLASHLIGHT
1. Loosen all four screws on the offset weaver mount using the allen wrench.
2. Slide in the flashlight and tighten screws, but do Not over tighten.
2. Loosen the thumb/screw on side of mount and slide on Picatinny rail until desired
position and tighten.
FEATURES
• Made of anodized aircraft grade aluminum
• Equipped with USA made CREE LED light bulb
• Works with both pistols and rifles
• Strobe/S.O.S. mode
• Offset Weaver style mount
• Integrated belt clip
• Indludes on/off end cap and wire pressure switch
SPECIFICATIONS
LIGHT BULB USA CREE LED
MAX OUTPUT 180 LUMENS
VOLTAGE 3W
LENGTH 5.5”
WEIGHT 8.7 oz.
BATTERY CR123A
CAUTION
Do not over tighten the screws or you may strip the
threaded holes. Stripped holes are NOT covered by warranty.