AIM Sports Mosin Nagant Mounts - Manual (Page 2)

MNG
M44 / Mosin Nagant Scope Mount
MNGS
M44 / Mosin Nagant Scope
Mount (short)
MNGTM
Mosin Nagant Tri-Rail Mount
w/ Extended Rails
CAUTION
Always check and be certain that the firearm is unloaded
before undertaking any work upon it.
MNG & MNGS INSTRUCTIONS
1. Punch out rear sight leaf cross pin and remove rear sight leaf
and springs.
2. Place scope mount between rear sight ears with two screws located to
the rear and one in the front.
3. Loosen screws, align with rear sight pin holes, and then replace screws.
4. Loosen or tighten screws in front and/or rear to adjust elevation until it
levels with gun barrels.
MNGTM INSTRUCTIONS
1. Remove extended rails and set to the side.
2. Punch out rear sight leaf cross pin and remove rear sight leaf
and springs.
2. Place scope mount between rear sight ears with two screws located to
the rear and one in the front.
3. Loosen screws, align with rear sight pin holes, and then replace screws.
4. Loosen or tighten screws in front and/or rear to adjust elevation until it
levels with gun barrels.
5. Replace extended rails.
CAUTION
Do not over tighten the screws or you may strip the
threaded holes. Stripped holes are NOT covered by warranty.
MOSIN NAGANT MOUNTS FEATURES
• Black anodized aircraft grade aluminum
• Accepts all standard Weaver/Picatinny 1913 accessories
• No drilling, tapping, or gunsmithing required
• Mounts to rear sight of models 91/30, M44, M38, M39 & Chinese 53
• Allows mounting of long eye relief scopes to standard rifle
SPECIFICATIONS
LENGTH
WEIGHT
MNG
6.5”
2.6 oz.
MNGS
6”
2.3 oz.
MNGTM
7”
6.5 oz.