AIM Sports Saiga Mounts - Manual (Page 2)

CAUTION
Always check and be certain that the firearm is unloaded
before undertaking any work upon it.
MTSG01 INSTRUCTIONS
1. Remove the four hex screws and the top rail.
2. Place lower piece of quad rail on barrel of rifle, butted against
receiver with notched portion of rail facing end of barrel.
3. Replace top rail with tapered end facing end of the barrel.
4. Replace the four hex screws.
MTSG02 & MTSG03 INSTRUCTIONS
1. Remove the six hex screws on top rail and slide off top rail.
2. Remove the four hex screws from the top plate and remove the
top plate.
3. Place lower piece of quad rail on barrel of rifle, butted against
receiver with notched portion of rail facing end of barrel.
4. Replace top plate and four hex screws, do NOT over tighten.
5. Slide top rail onto top plate with long portion of rail facing the
butt stock.
6. Replace the six hex screws, do NOT over tighten.
FEATURES
• Black anodized aircraft grade aluminum
• Accepts all standard Weaver/Picatinny 1913 accessories
• Includes black rubber rail covers
• 2-Piece construction
• Fits most 7.62X39 5.45X39 Saiga models (MTSG01 only)
• Fits Saiga 12 only (MTSG02 & MTSG03 only)
• Extended accessory top rail (MTSG02 only)
SAIGA MOUNTS
MTSG01
Saiga Quad Rail Mount
MTSG02
Saiga 12G Quad Rail Mount
MTSG03
Saiga 12G Quad Rail Mount
CAUTION
Do not over tighten the screws or you may strip the
threaded holes. Stripped holes are NOT covered by warranty.