AiM MXL - Manual (Page 15)

MXL
User manual
Release 1.24
To activate High/Low power mode it is necessary to unscrew the back of the
transmitter case as shown here below on the left.
The image here above on the right shows possible working mode. The transmitter
comes set in low power mode: see images on top on the right. To set high power
mode insert both clips in the jumper: image bottom on the right.
WARNING: verify the number of transmitters installed on the track before
installing one’s own. It is in effect possible that transmitters – additional to the
one placed on the start/finish line – are installed on the track. The simplest
way to mark laps and splits is using the same transmitter(s) for all drivers.
Use obscuring time function (to be set in the software configuration of the logger) to
be sure that MXL reads only the desired transmitter(s).
Refer to Race Studio Configuration user manual for detailed information
concerning the system configuration.
www.aim-sportline.com 14