AiM ECU Bridge User Manual
Page 12
ECU Bridge
User Manual
Release 1.08
www.aim-sportline.com
2
Chapter 3 – Driver, configuration, sampled data visualisation,
engaged gear computation and maintenance
Once ECU Bridge installation and connection is over it is necessary to configure it using
Race Studio Configuration software freely
,
“Download area /Software”.
Once software and driver installed connect ECU Bridge to the PC using the USB cable
included in the kit. Plug the cable three pins connector in ECU Bridge USB connector
shown below, run the software and follow the procedure here explained.
Press “AIM system manager”>>“SMC bridge”>>”New” and fill in “New configuration” panel;
• “Data Logger type”: is already set on ECU Bridge;
• “ECU Manufacturer”: select the correct vehicle or OBD_II
• “ECU Model” select ECU model or OBDII protocol;
• select the desired measure units and press “OK”.
The system comes back to “System Manager” window: press “SmartyCam Functions
setting” button top right in the window and select the channels to show.
11