AiM RPM Bridge - Manual (Page 11)

RPM Bridge
User manual
Release 1.03
www.aim-sportline.com 10
In case an AIM Display is available it needs configuration: activate “Display” layer and select
the right display. Refer to Race Studio Configuration user manual to know how to configure
each display.
7
5.1 – How to transmit the configuration
To transmit the configuration the logger has to be switched on and connected to the PC USB
port through the proper cable. Press “Transmit” button in “System manager” window and the
system will automatically transmit the configuration to the device.
1 1
5.1.1 – Possible problems while transmitting the configuration
While transmitting the configuration this error message can appear:
Check that the USB cable is correctly plugged in
the PC and in the device USB port, that the logger
is switched on and try again transmitting the
configuration.
8
5.2 – Online
When the configuration has been transmitted to the logger, it is suggested to enter “Online”
pressing the corresponding button on the menu bar, on the left vertical keyboard to verify that
all works properly. Ensure that RPM Bridge is switched on and well connected to the PC.